31.1 Controlling External I/O
31.2 Settings Guide
31.3 Controlling External I/O with the Display Unit's Internal DIO
31.4 Using FLEX NETWORK External I/O
31.5 Controlling External I/O with LT
31.6 Controlling I/O in LT3000 Series and EX Modules
31.7 Controlling External I/O with CANopen
    31.7.1 Setting Up CANopen
    31.7.2 Connecting Third-party Slaves - CANopen
    31.7.3 Mapping I/O - CANopen
    31.7.4 Using I/O Driver Instructions - CANopen
    31.7.5 HTB Standard Input/Output
    31.7.6 Expanding I/O Using EX Module
    31.7.7 I/O Driver Settings Guide - CANopen
    31.7.8 Error Information - CANopen
    31.7.9 Restrictions
    31.7.10 Communication Setting HTB Objects (1000h to 1FFFh)
    31.7.11 Manufacturer HTB Object (2000h to 5FFFh)
       31.7.11.1 Object 2000h: Standard input parameter
       31.7.11.2 Object 2100h: Analog Input Data Type
       31.7.11.3 Object 2101h: Analog Input Data Range
       31.7.11.4 Object 2102h: Analog Input Lower Limit
       31.7.11.5 Object 2103h: Analog Input Upper Limit
       31.7.11.6 Object 2200h: Analog Output Data Type
       31.7.11.7 Object 2201h: Analog output data range
       31.7.11.8 Object 2202h: Analog output lower limit
       31.7.11.9 Object 2203h: Analog output upper limit
       31.7.11.10 Object 3000h: Module Diagnosis
       31.7.11.11 Object 3200h: Parameters Status
       31.7.11.12 Object 3201h: Configuration Stack Number
       31.7.11.13 Object 3202h: Restoring last save parameters
       31.7.11.14 Object 3300h: Reset Extension Bus
    31.7.12 Standard Device HTB Object (6000h to 9FFFh)
31.8 Controlling External I/O in the LT3000 Series and AnyWire Master Unit