Please refer to the following for the models supporting Selector List.
1.5 Supported Features
When multiple selector list parts are placed, multiple selector function lists cannot be displayed at the same time.
Do not draw Selector List parts on a Window Screen. The Selector Function List will not appear. The same applies when you load the window using the [Call Screen] command.
The Selector Function List is displayed using a special window or a local window. If the maximum number of windows is already open, the Selector Function List does not appear.
12.9 Displaying Multiple Windows on a Single Screen
Except for the GP4000 Series, LT4000 Series or IPC Series, the Selector Function List window is created in 4 dot units.
When using Call Screen or some other function to create a window, if the position of the window is not in a 4 pixel interval, the position will be slightly adjusted.
When the window is angled 0 or 180 degrees and the horizontal width is not in 4 pixel units, and if a scroll bar is required, the scroll bar will be slightly smaller to adjust to the 4 pixel interval.
If there is no scroll bar, the horizontal width of the display of the selector function list will be smaller.
(Moves by a maximum of 3 dots)
When the angle is 90/270 degrees and the horizontal width is not 4 dots, the area in the last selector function list will be displayed larger in accordance with the total 4 dots. (Moves by a maximum of 3 dots)
At the top of each screen (including header/footer), even if you draw multiple Selector List parts with the same Parts ID, only the first drawn Selector List will display and run. In the same way, if you use the [Call Screen] command to load a screen with a Selector List with the same Parts ID, only the first displayed Selector List will run.
The Selector List adjusts its horizontal width to accommodate the maximum number of characters in its list. You cannot make the horizontal width smaller.
When [Font] is set to [Image Font], depending on the font you set in the [Select Font] field, the part width may be wider than the displayed item names. To match the width of items, please select any [Font Type] other than [Image Font], or change the selected font.
In the [Font] tab, when [Font Type] is [Image Font], depending on the font size the drop-down cursor in the part may not display.
Please adjust the size of selector list part until the drop-down cursor is visible.
For restrictions on using [Anti-alias] with Image Fonts, see the following.
6.6.2 Restrictions for the Image Font